LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Fuel Delivery System - 3.3L) >> Filler-Neck Assembly >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  2. Remove the rear-left wheel & tire and wheel house cover.
  3. Remove the fuel filler cap after opening the fuel filler door.
  4. Disconnect the fuel filler hose (A).
    G12663857Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the vent hose quick-connector (A).
    G12663858Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the mounting nuts (A), and then remove the fill-neck assembly.
    G12663859Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals