Repair Procedures: Replacement
CAUTION:
- Put on gloves to prevent hand injuries.
NOTE:
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
- Take care not to bend or scratch the trim and panels.
- Remove both stoppers (B) from the glove box (A) by turning the stoppers.
- Separate the air damper (A) from the glove box (B).
- Disconnect the push-pins (A) and then remove the glove box (B).
- Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.