[Fuel sender]
WARNING: This page is about a different variant/trim than selected.
- Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
- Remove the fuel pump assembly.
- Using an ohmmeter, measure the resistance between terminals 1 and 2 of sender connector (A) at each float level.
Pin No Description 1 Fuel sender ground (-) 2 Fuel sender signal (+) 3 Fuel pump motor ground (-) 4 Fuel pump motor (W) 5 Fuel pump motor (V) 6 Fuel pump motor (U) CAUTION: [Main fuel sender + sub fuel sender synthesis of resistance] - Also check that the resistance changes smoothly when the float moves from "E" to "F".
Position Resistance (Ω) Capacity (l ) E 296 - 304 4.5 1/2 154.5 - 160.5 37.3 F 13 - 17 58.5