Ground Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Turn "OFF" the ignition switch and disconnect OTS connector and then Turn "On" the ignition switch.
- Measure voltage between signal terminal of OTS harness connector and chassis ground. (Measurement "A".)
- Measure voltage between signal and ground terminals of OTS harness connector. (Measurement "B".)
Specification: Voltage difference between measurement "A" and "B" is below 200 mV.
- Is the measured voltage within specification?
YES
- Go to next procedure.
NO
- Repair contact resistance or open in harness and go to "VERIFICATION OF VEHICLE REPAIR " procedure.