LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2019 >> G70 3.3T Dynamic, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Engine Control System Diagnosis - 2.0L (1 Of 4)) >> DTC P0198-00: Engine Oil Temperature Sensor High Input >> Component Inspection >> Oil Temperature Sensor Inspection

Oil Temperature Sensor Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn "OFF" the ignition switch. Disconnect OTS connector.
  2. Measure the resistance between signal terminal and ground terminal of OTS connector. (Component side)

    Specification:  Approx. 5V

    Temp. (°C) Temp. (°F) Resistance (kΩ) Temp. (°C) Temp. (°F) Resistance (kΩ)
    -20 -4 16.52 40 104 1.11
    0 32 6 60 140 0.54
    20 68 2.45 80 176 0.29
  3. Is the measured resistance within specification?

    YES 

    • Clear DTC and Test-drive under the enable conditions. After the road test, if this DTC is set, recheck resistance. If not, it is intermittent fault. Go to "VERIFICATION OF VEHICLE REPAIR ".

    NO 

    • Check OTS for contamination, deterioration, or damage. Substitute with a known-good OTS and check for proper operation. If the problem is corrected, replace OTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals