LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2019 >> G70 3.3T Dynamic, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Engine Control System Diagnosis - 2.0L (1 Of 4)) >> DTC P0136-00: O2 Sensor Circuit (Bank 1/Sensor 2) >> Wiring Inspection >> Signal Circuit Inspection >> Check Resistance

Check Resistance

WARNING: This page is about a different variant/trim than selected.
  1. Turn "OFF" the ignition switch. Disconnect HO2S connector.
  2. Measure resistance between both ends of signal terminal of HO2S (B1/S1) harness.

    Specification:  Approx. 0Ω

  3. Is resistance within the specification?

    YES 

    NO 

    • Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.
scientia non olet · About LEMON Manuals