Thermostat Inspection
WARNING: This page is about a different variant/trim than selected.
- Remove the thermostat and check the following items:
- Stuck or damaged
- Verify the temperature at which the valve is open
- Valve opening temperature: 82°C (180°F)
- Full opening temperature: 95°C (203°F)
- Is the thermostat normal?
YES
- Clear DTC and Test-drive under Prerequisite Condition above-mentioned. After the test, If this DTC is set, recheck it thoroughly. If not, it is intermittent fault, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good Thermostat and check for proper operation. If the problem is corrected, Go to "VERIFICATION OF VEHICLE REPAIR " procedure.