LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2019 >> G70 3.3T Dynamic, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Engine Control System Diagnosis - 2.0L (1 Of 4)) >> DTC P0125-00: Insufficient Coolant Temperature For Closed Loop F/Control >> Wiring Inspection >> Terminal And Connector Inspection

Terminal And Connector Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ETC Motor, TPS and ECM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.
  2. Connect the GDS and go to "Current Data".
  3. Monitor ECT Sensor values in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).
  4. Any change in the values indicates a poor connection. Was a connector problem found?

    YES 

    NO 

scientia non olet · About LEMON Manuals