ECT Sensor Inspection

WARNING: This page is about a different variant/trim than selected.

Measure the resistance between signal and ground terminal of ECT Sensor connector. (Component side)

Temperature °C (°F)	Resistance (kΩ)	Temperature °C (°F)	Resistance (kΩ)
-40 (-40)	48.14	20 (68)	1.15
-20 (-4)	14.13 ~ 16.83	40 (104)	0.59
0 (32)	5.79	60 (140)	0.32
10 (50)	2.31 ~2.59

Is resistance within the specification?
YES
- Clear DTC and Test-drive under the enable conditions. After the road test, if this DTC is set, recheck resistance. If not, it is intermittent fault. Go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Check ECT Sensor for contamination, deterioration, or damage. Substitute with a known-good ECT Sensor and check for proper operation. If the problem is corrected, replace ECT Sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.