ECTS Inspection

WARNING: This page is about a different variant/trim than selected.

Measure the resistance between signal terminal and ground terminal of ECTS connector. (Component side)

Specification:

Temp. (°C/°F)	Resistance (kΩ)	Temp. (°C/°F)	Resistance (kΩ)
-40/-40	47.74 ~ 54.54	40/104	1.08 ~ 1.21
-20/-4	14.13 ~ 16.83	60/140	0.56 ~ 0.61
0/32	5.28 ~ 6.3	80/176	0.31 ~0.33
20/68	2.31 ~2.6	100/212	0.18 ~ 0.19

Is the measured resistance within specification?
YES
- Clear DTC and Test-drive under the enable conditions. After the road test, if this DTC is set, recheck resistance. If not, it is intermittent fault. Go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Check ECTS for contamination, deterioration, or damage. Substitute with a known-good ECTS and check for proper operation. If the problem is corrected, replace ECTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.