IATS Inspection

WARNING: This page is about a different variant/trim than selected.

Measure the resistance between signal terminal and ground terminal of the sensor connector (Component side).

Specification:

Temp. (°C/°F)	Resistance (kΩ)	Temp. (°C/°F)	Resistance (kΩ)
-40/-40	40.93 ~ 48.35	20/68	2.31 ~2.56
-20/-4	13.89 ~ 16.02	40/104	1.07 ~ 1.20
0/32	5.38 ~ 6.08	60/140	0.54 ~ 0.06
10/50	3.48 ~ 3.9	80/176	0.29 ~ 0.33

Is the measured resistance within specification?
YES
- Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check IATS for contamination, deterioration, or damage. Substitute with a known-good IATS and check for proper operation. If the problem is corrected, replace IATS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.