Fuel Pressure Regulator Valve (FPR) Inspection
WARNING: This page is about a different variant/trim than selected.
- Turn "OFF" the ignition switch.
- Disconnect the Fuel Pressure Regulator Valve (FPR) connector.
- Connect probes to each terminal of the Fuel Pressure Regulator Valve (FPR) connector.
- Measure Fuel Pressure Regulator Valve (FPR) resistance.
Specification: Approx. 0.41Ω
- Is the measured resistance within specifications?
YES
- Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known good Fuel Pressure Regulator Valve (FPR) and check for proper operation. If the problem is corrected, replace Fuel Pressure Regulator Valve (FPR) and go to "VERIFICATION OF VEHICLE REPAIR " procedure.