Component Inspection
WARNING: This page is about a different variant/trim than selected.
- Turn "OFF" the ignition switch.
- Disconnect OCV (Exhaust) connector.
- Measure resistance between power terminal and control terminal of OCV (Exhaust) connector (Component side).
Specification:
Oil Control Valve (OCV) Normal Parameter At 20°C (68°F) Coil Resistance (Ω) 6.9~7.9Ω - Is resistance within specification?
YES
- Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good OCV (Exhaust) and check for proper operation. If the problem is corrected, replace OCV (Exhaust) and go to "VERIFICATION OF VEHICLE REPAIR " procedure.