LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2019 >> G70 3.3T Dynamic, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Engine Control System Diagnosis - 2.0L (1 Of 4)) >> DTC P0070-00: Ambient Air Temperature Sensor Circuit >> Wiring Inspection >> Terminal And Connector Inspection

Terminal And Connector Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the AAT sensor and ECM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.
  2. Connect the GDS and go to "Current Data".
  3. Monitor AAT sensor in Current Data, check and wiggle the harness(es), connector(s), and terminal(s).
  4. Any change in the values indicates a poor connection. Was a connector problem found?

    YES 

    NO 

    • The main cause of this code is that CAN signal representing short or open in Ambient Air Temperature circuit from Air Conditioner (FATC) system is detected.
    • Check DTCs in Air Conditioner (FATC) system. If there is a code in the system, Repair according to DTC diagnostic guide of Air Conditioner (FATC) system.
scientia non olet · About LEMON Manuals