Check RCV Resistance

WARNING: This page is about a different variant/trim than selected.

Ignition switch is turned "OFF".
Disconnect RCV connector.

Measure resistance between power terminal and control terminal of the solenoid valve connector (Component side)

Specification:

ITEM	Normal Parameter At 20°C (68°F)
Resistance (Ω)	28.3 ~ 31.1

Is the measured resistance within specification?
YES
- Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good RCV and check for proper operation.
  If the problem is corrected, replace RCV and go to "VERIFICATION OF VEHICLE REPAIR " procedure.