DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Deviation check between actual CAM position and CAM setpoint position in case of changing setpoint (slow response of actuator)
|
- Poor connector Connection
- Contamination of Oil/Clogged Oil Line
- Faulty Oil Control Valve
- Faulty Cam Phaser
- Faulty Intake CVVT Assembly
|
| Enable Condition |
- Camshaft set-point movement more than 16° within in less than 1.5s.
- Camshaft set-point moved more than 0 times since engine start
- Engine speed at between 450 RPM and 5000 RPM
- Engine oil temperature at between 68°F (20°C) and 248°F (120°C)
- Battery voltage at between 10V and 16V
|
| Threshold Value |
- CAM position movement less than 4° within 1s.
|
| Diagnostic Time |
|
| Mil On Condition |
|