LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2019 >> G70 3.3T Dynamic, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Idle Stop & Go (ISG) System - 2.0L) >> Starter >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Remove the LH engine mounting support bracket.

    (Refer to Engine Mechanical System - "ENGINE MOUNTING ")

  3. Remove the stater solenoid "B" terminal mounting nut (B), and then disconnect the stater cable and ST connector (A).
    G13539532Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the starter after loosening the mounting bolt (A).
    G13539533Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals