Starter Solenoid Inspection
WARNING: This page is about a different variant/trim than selected.
- Disconnect the lead wire from the M-terminal of solenoid switch.
- Connect the battery as shown. If the starter pinion pops out, it is working properly.NOTE:
- To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.
- Disconnect the battery from the M terminal.
If the pinion does not retract, the hold-in coil is working properly.
NOTE:- To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.
- Disconnect the battery also from the body. If the pinion retracts immediately, it is working properly.NOTE:
- To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.