LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2019 >> G70 3.3T Dynamic, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Clutch System) >> Clutch Pedal >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse the removal procedures.

    Information 

    CAUTION:
    1. Lightly tighten the clutch & brake upper mounting nuts (A).
      G13539675Courtesy of HYUNDAI MOTOR AMERICA
    2. Install the clutch & brake mounting nuts (B)
      G13539676Courtesy of HYUNDAI MOTOR AMERICA
    3. Re-tighten the clutch & brake upper mounting nuts.
  2. After be equipped, perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid.

    (Refer to Clutch System - "CONCENTRIC SLAVE CYLINDER ASSEMBLY ")

  3. After installation, bleed the brake system.

    (Refer to Brake System - "BRAKE BLEEDING PROCEDURES ")

scientia non olet · About LEMON Manuals