Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Install the component to the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
- Keep the sensing element and connector free from cleaner, spray or grease as oil substance may cause the sensor to malfunction.
- Sensor and its wiring may get damaged from contact with the exhaust system. (e.g. Exhaust Manifold, Catalytic Converter)
- Install in the reverse order of removal.
Heated oxygen sensor:
39.2 - 49.1 N.m (4.0 - 5.0 kgf.m, 28.9 - 36.2 lb-ft)