[Steering Column Shroud Lower Panel]

CAUTION:

Put on gloves to prevent hand injuries.

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
Take care not to bend or scratch the trim and panels.

Remove the crash pad upper panel.
(Refer to Crash Pad - "CRASH PAD LOWER PANEL ")
Loosen the mounting screws by turning the steering wheel to the left and right, and remove the steering column shroud lower panel (A).

Courtesy of
Disconnect the connector (A).

Courtesy of
Install in the reverse order of removal.

information

Make sure the connector is connected properly.
Replace any damage clips.