Repair Procedures: Replacement

CAUTION:

Be careful not to scratch or dent the crash pad garnish and door trim upper garnish because these parts are made of weak material (real wood).
Put on gloves to prevent hand injuries.

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
Take care not to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

Courtesy of
After loosening the mounting screw, remove the crash pad side garnish assembly [RH] (A).

Courtesy of
Disconnect the emergency light switch connector (A).

Courtesy of
Install in the reverse order of removal.

information

Make sure the connector is connected properly.
Replace any damage clips.