Disc Rotor: Remove & Replace
WARNING: This page is about the Sierra 3500 HD AT4, 6.6L Eng VIN 7, which is a different variant/trim than selected.
Includes: Replace Pads (if necessary). DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Front,w/Dual Rear Wheels,Both | 1.6 | B | ||
| Front,w/Dual Rear Wheels,One Side | 0.9 | B | ||
| Front,w/o Dual Rear Wheels,Both | 1.0 | B | ||
| Front,w/o Dual Rear Wheels,One Side | 0.6 | B | ||
| Rear,w/Dual Rear Wheels,Inboard Mounted,Both | Includes: Repack Wheel Bearings. Includes: R&I Axle Shafts. | 4.8 | B | |
| Rear,w/Dual Rear Wheels,Inboard Mounted,One Side | Includes: Repack Wheel Bearings. Includes: R&I Axle Shaft. | 2.5 | B | |
| Rear,w/o Dual Rear Wheels,Outboard Mounted,Both | 1.0 | B | ||
| Rear,w/o Dual Rear Wheels,Outboard Mounted,One Side | 0.6 | B | ||
| Additional Procedure: DISC ROTOR: Remove & Replace: | ||||
| w/Dual Rear Wheels add, Each Side | 0.1 | B | ||
| Combination Procedure: BRAKE PAD LIFE MONITORING SYSTEM: Reset: | ||||
| Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | ||
| Combination Procedure: BRAKE PAD WEAR SENSOR: Replace: | ||||
| Front,One Side | 0.1 | B | ||
| Rear,One Side | 0.1 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
| Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots. | ||||
| Each Additional | 0.3 | B | ||
| One | 0.5 | B | ||
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: OIL SEAL WEAR SLEEVE: Replace: | ||||
| w/Dual Rear Wheels,Rear Axle,Each | 0.2 | B | ||