Torque Converter Housing with Fluid Pump Assembly Installation
WARNING: This page is about a different car, the 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | A/Trans Fluid Trough Check Ball - Hybrid Models |
| 2 | Fluid Pump Seal Assembly |
| 3 | Torque Converter Housing Gasket |
| 4 | Torque Converter (w/Fluid Pump) Housing Assembly
NOTE:
Rotate the differential slightly in each direction using the rotating tool to align the Differential Pinion Gears with the Differential Ring Gear in the Torque Converter Housing.
Special Tools
For equivalent regional tools, refer to Special Tools . |
| 5 | Torque Converter and Differential Housing Bolts M8 x 30 (Qty: 15)
CAUTION:
Refer to Fastener Caution . Procedure Tighten the bolts in sequence shown. Tighten 10 N.m (89 lb in) then rotate the bolt an additional 50 degrees Special Tool EN-45059 Angle Meter or equivalent For equivalent regional tools, refer to Special Tools . |