Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation

WARNING: This page is about a different car, the 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Low and Reverse Clutch Assembly (OWC) NOTE: The low and reverse clutch assembly should rotate freely in one direction and lock in the opposite direction. Rotate the clutch assembly and listen/feel for the ratchet of the clutch in it's designed rotational direction. With the valve body face at the 6 o'clock position, align the largest flat area of the low and reverse clutch assembly between the 2 o'clock and 5 o'clock position.
2	Low and Reverse Clutch Backing Plate NOTE: With the valve body face at the 6 o'clock position, align the largest tab of the low and reverse clutch backing plate at the 6 o'clock position.
3	Low and Reverse Clutch Plate Assembly (Qty: 3)
4	Low and Reverse Clutch Plate (Qty: 3) NOTE: With the valve body face at the 6 o'clock position, align the largest tab of the low and reverse clutch plate at the 6 o'clock position.
5	Low and Reverse Clutch Apply (Waved) Plate NOTE: Ensure the correct waved plate is being installed. The 1 - 2 - 3 - 4 clutch and low and reverse clutch apply (waved) plates are visually similar, however the low and reverse clutch apply (waved) plate is thicker. Align the low and reverse clutch apply (waved) plate as shown.