LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2024 >> Terrain SLT, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Automatic Transmission - 6T40 (MNH) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Lift Plate and Holding Fixture Installation

Lift Plate and Holding Fixture Installation

WARNING: This page is about a different car, the 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
GM1891300Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Transmission Case
WARNING:

Handle with care, the transmission assembly weighs over 83 Kg (183 lbs). Bodily injury could occur if not handled properly.

WARNING:

Lock pin must be secured into the bench fixture to hold the transmission and prevent bodily injury.

CAUTION:

Refer to Fastener Caution .

Procedure

  1. Install DT-47811-A  Transmission Lift Plate
  2. Tighten bolts and nut to 12 N.m (106 lb in).
  3. Raise the transmission with an overhead hoist.
  4. Install DT-46625  Transmission Holding Fixture.
  5. Adjust mounting block on fixture to match bosses on case, then tighten bolts to 13 N.m (10 lb ft).
  6. Ensure the DT-46625  Transmission Holding Fixture is mounted to a bench that is properly supported and will support the weight of the transmission assembly without tipping.
  7. Install lock pin for DT-3289-20  Holding Fixture.
NOTE:

Only 2 bolt holes on the lift plate will align with the bosses on the transmission case. This is sufficient for lifting the transmission to install the holding fixture.

Special Tools

  • DT-3289-20  Holding Fixture
  • DT-46625  Transmission Holding Fixture
  • DT-46625-10  Transmission Holding Fixture Adapter
  • DT-47811-A  Transmission Lift Plate

For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals