2-6 Clutch Piston Installation

WARNING: This page is about a different car, the 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	2 - 6 Clutch Piston Assembly NOTE: Position the 2 - 6 piston air bleed and large slot toward the top of the case. DT-47796 seal protector prevents the piston seal lip from damage during installation. Apply a thin coat of ATF to the I.D. of the DT-47796 seal protector to ease installation of the piston. Special Tool DT-47796 Seal Protector For equivalent regional tools, refer to Special Tools .
2	2 - 6 Clutch Spring
3	2 - 6 Clutch Spring Retainer CAUTION: Regulate the air pressure to 276 kPa (40 psi) maximum. High pressure could cause the piston to over travel and damage the piston seals. NOTE: Place the retainer on the 2-6 clutch spring and align the retainer opening with the largest gap in the case splines toward the bottom of the case. The retainer opening should be supported by a spline tooth of the case. Apply shop air to the clutch fluid feed hole in the case to verify proper piston operation. Special Tools DT-47797 Spring Installer DT-48056 Spring Compressor Bridge For equivalent regional tools, refer to Special Tools .

Callout

Component Name

2 - 6 Clutch Piston Assembly

NOTE:

Position the 2 - 6 piston air bleed and large slot toward the top of the case.
DT-47796 seal protector prevents the piston seal lip from damage during installation. Apply a thin coat of ATF to the I.D. of the DT-47796 seal protector to ease installation of the piston.

Special Tool
DT-47796 Seal Protector
For equivalent regional tools, refer to Special Tools .

2 - 6 Clutch Spring

2 - 6 Clutch Spring Retainer

CAUTION:

Regulate the air pressure to 276 kPa (40 psi) maximum. High pressure could cause the piston to over travel and damage the piston seals.

NOTE:

Place the retainer on the 2-6 clutch spring and align the retainer opening with the largest gap in the case splines toward the bottom of the case. The retainer opening should be supported by a spline tooth of the case.
Apply shop air to the clutch fluid feed hole in the case to verify proper piston operation.

Special Tools

DT-47797 Spring Installer
DT-48056 Spring Compressor Bridge

For equivalent regional tools, refer to Special Tools .