LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2024 >> Terrain SLT, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Automatic Transmission - 6T40 (MNH) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Control Lever Knob Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2024 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the parking brake.
  2. Shift the transmission control into Reverse position.
  3. GM4666021Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The transmission control lever boot snaps to the lever boot bezel in four locations (arrows): two on the passenger side, one on the driver side, and one on the front side.

    Unclip the transmission control lever boot (1) from the lever boot bezel (2), using a flat bladed tool.

  4. Pull the lever boot up to gain access to the electrical connector (3).
  5. GM4422377Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) - Disconnect

  6. GM4422378Courtesy of GENERAL MOTORS COMPANY

    Detach the transmission control lever boot from the transmission control lever knob.

    1. Pull the transmission control lever boot over the transmission control lever knob to gain access to the upper boot ring (1).
    2. Press the upper boot ring (arrows) to disengage the snaps.
    3. Push the upper boot ring along with the lever boot down.
    4. Guide the wiring harness (2) upwards out of the upper boot ring.
  7. GM4421903Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Press the button while sliding the lever knob extension downwards.

    Detach the transmission control lever knob extension (1) from the lever knob with a flat bladed tool, then slide the lever knob extension downwards.

  8. GM4422379Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The graphic is shown without the transmission control lever knob extension for clarity.

    Wiring Harness (1) - Position aside

    1. Detach the wiring harness from the 2 holders (2).
    2. Guide the wiring harness upwards out the bottom hole of the transmission control lever knob extension.
  9. GM4421904Courtesy of GENERAL MOTORS COMPANY

    Remove the transmission control lever knob retainer (1).

  10. GM4422380Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    This is a press fit and will require some force to pull the transmission control lever knob off. Before applying an upward force, ensure the wiring harness is free.

    Transmission Control Lever Knob (1) @ Transmission Control Lever - Remove

scientia non olet · About LEMON Manuals