Removal Procedure
- Prepare the brake system control module for removal with Service Programming System (SPS) and follow the on-screen instructions.
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
Electrical Connector (1) @ Brake System Control Module - Disconnect
Electronic Brake Control Module Bolt (1) - Remove and DISCARD [4x]
- CAUTION:
When removing the Brake System Control Module (BSCM) from the Master Cylinder Assembly, ensure the valve coils in the (BSCM) clear the pins in the Master Cylinder Assembly. If the coils or pins are damaged the complete Master Cylinder Assembly will require replacement.
Brake System Control Module (1) - Remove