Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
- Thoroughly clean the brake master cylinder reservoir and the brake master cylinder body to remove any dirt and debris.
Electrical Connector (1) @ Brake Fluid Level Sensor - Disconnect
- Place a drain pan under the vehicle.
Brake Master Cylinder Reservoir Bolt (1) - Remove
Brake Master Cylinder Reservoir (1) - Remove
Brake Master Cylinder Reservoir Grommet (1) - Remove and DISCARD [3x]
- Transfer components as necessary.
- Clean any brake fluid from the underbody area and remove the drain pan from under the vehicle.