|
Preliminary Procedures
- It is only necessary to lower the headlining. Only do those steps in the headlining procedure that will allow access to the component being removed. Headlining Trim Panel Replacement (Without C3U)
, or Headlining Trim Panel Replacement (With C3U)
- Disconnect the electrical connector.
|
| 1 |
Sunroof Sunshade Motor Bolt [3x]
Tighten
5 N.m (44 lb in) |
| 2 |
Sunroof Sunshade Motor Procedure
- With a turning motion, pull downward on the sunroof sunshade motor. Disengage the motor from the drive cables.
- Install the sunroof sunshade motor to the frame with a turning motion, pushing upward. This will engage the motor into the drive cables.
- Sunroof/Sunshade Motor Initialization
- Verify the sunroof sunshade motor operation.
|