Preliminary Procedure
Using a suitable tool, press the button to release the belt from the mini buckle. Rear Seat Center Belt Retractor Replacement |
| 1 |
Rear Seat Actuator Finish Cover Bolt Cap |
| 2 |
Rear Seat Bolt [11x]
Procedure
- Fold the seat back down.
- Remove the front bolts.
- Fold the seat bottom up to gain access to the rear bolts.
- If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
- Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
- Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
- Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the component.
Tighten
45 N.m (33 lb ft) |
| 3 |
Rear Seat Procedure
- Disconnect electrical connections, if applicable.
- Disconnect the recliner cable from the release lever cable equalizer. Lift the carpet flap to access, slide the retainer door open and disconnect the cable.
- Remove elastic band from the seat belt buckles.
- With the aid of an assistant remove the rear seat by lifting and pulling the seat upward to disengage it from the floor.
- Separate the rear seats. Rear Seat Separation
|