Installation Procedure
Connect the electrical connector.
- Head-Up Display (2) - Install
- Head-Up Display Bolt (1) - Install and tighten [2x] 2.5 N.m (22 lb in)
Head-Up Display Bolt (1) - Install and tighten [2x] 2.5 N.m (22 lb in)
Instrument Cluster (2) - Install - Instrument Cluster Replacement (Equinox) , or Instrument Cluster Replacement (Terrain)
Instrument Panel Cluster Trim Plate (1) - Install - Instrument Panel Cluster Trim Plate Replacement (Equinox) , or Instrument Panel Cluster Trim Plate Replacement (Terrain)
Instrument Panel Trim Pad - Right Side (1) - Install - Instrument Panel Trim Pad Replacement - Right Side (Equinox) , or Instrument Panel Trim Pad Replacement - Right Side (Terrain)
Electronic Transmission Shift Control Push-button (2) - Install - Electronic Transmission Shift Control Push-button Replacement (Terrain)
Front Floor Console Transmission Shift Opening Bezel (1) - Install - Front Floor Console Transmission Shift Opening Bezel Replacement (Terrain)
Instrument Panel Trim Pad - Left Side (1) - Install - Instrument Panel Trim Pad Replacement - Left Side (Equinox) , or Instrument Panel Trim Pad Replacement - Left Side (Terrain)
Instrument Panel Extension (1) - Install - Instrument Panel Extension Replacement (Terrain without UV7) , or Instrument Panel Extension Replacement (Terrain with UV7)
- NOTE:
Left side shown, right side similar.
Install the left and right instrument panel outer trim cover (1). Instrument Panel Outer Trim Cover Replacement (Equinox) , or Instrument Panel Outer Trim Cover Replacement (Terrain)
- NOTE:
Left side shown, right side similar.
Install the left and right windshield garnish molding (1). Windshield Garnish Molding Replacement (Equinox) , or Windshield Garnish Molding Replacement (Terrain)
Ensure that the tab on the head-up display is properly seated in the mating hole for proper alignment.
Refer to Fastener Caution .