Wheel Seal: Remove & Replace
WARNING: This page is about the Sierra 3500 HD AT4, 6.6L Eng VIN 7, which is a different variant/trim than selected.
Includes: Repack and adjust Bearings (where applicable).| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Rear Axle,w/Dual Rear Wheels,Both | 3.4 | B | ||
| Rear Axle,w/Dual Rear Wheels,One Side | 1.8 | B | ||
| Rear Axle,w/Single Rear Wheels,Both | 3.2 | B | ||
| Rear Axle,w/Single Rear Wheels,One Side | 1.7 | B | ||
| Combination Procedure: BRAKE PAD LIFE MONITORING SYSTEM: Reset: | ||||
| Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | ||
| Combination Procedure: BRAKE PAD WEAR SENSOR: Replace: | ||||
| Rear,One | 0.1 | B | ||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| w/Single Rear Wheels,Lateral Runout,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| w/Single Rear Wheels,Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: OIL SEAL WEAR SLEEVE: Replace: | ||||
| Rear Axle,Each | 0.2 | B | ||