Installation Procedure
Connect the electrical connector and install the wiring harness retainers as necessary.
- Align the hood primary and secondary latch with the markings made with the grease pencil.
- Hood Primary and Secondary Latch (2) - Install
- Hood Primary and Secondary Latch Bolt (1) - Install and tighten [2x] - Fastener Specifications
Front Stowage Compartment Latch Actuator Cable (1) - Install [2x]
- Hood Primary and Secondary Latch Release Cable (2) - Install
Front Trim Finish Compartment (2) - Install - Front Trim Finish Compartment Removal and Installation
CAUTION:
Refer to Fastener Caution .