Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Using a flat bladed plastic trim tool, release the retaining clips.
Instrument Panel Outer Trim Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Instrument Panel Knee Bolster Bolt (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Using a flat bladed plastic trim tool, release the retaining clips.
Reposition the component to access the electrical connectors.
Disconnect the electrical connectors.
Instrument Panel Knee Bolster (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat bladed plastic trim tool, release the retaining clips.
Parking Brake Control Switch (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat bladed plastic trim tool, release the retaining clips.
Accessory Power Receptacle Switch (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat bladed plastic trim tool, release the retaining clips.
Dimmer Switch (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat bladed plastic trim tool, release the retaining clips.
Trailer Brake Control Switch (1) - Remove