Removal Procedure

Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
Oil Filler Cap - Remove
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
To avoid small parts like bolts or retainers fallen into the engine, install the Oil Filler Cap.

Oil Filler Cap (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Positive Crankcase Ventilation Fresh Air Tube (1) @ Air Cleaner Outlet Duct - Disconnect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Outlet Duct Front Clamp (1) - Loosen
Air Cleaner Outlet Duct Clamp (5) - Loosen
Air Cleaner Outlet Duct Bolt (2) - Remove [2x]
Air Cleaner Outlet Duct Nut (3) - Remove
Air Cleaner Outlet Duct (4) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Radiator Surge Tank Bolt (1) - Remove
Without opening the cooling system position the radiator surge tank (2) aside.
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Pipe Nut (1) - Remove
Remove and DISCARD the tape securing the brake pipes.
Cap the brake master cylinder outlet to prevent brake fluid loss and contamination.
Brake Pipe (2) @ Front Brake Pipe Clip (3) - Disengage
Drivetrain and Front Suspension Cradle - Remove - Drivetrain and Front Suspension Cradle Removal and Installation (AWD) , or Drivetrain and Front Suspension Cradle Removal and Installation (FWD) , or Drivetrain and Front Suspension Cradle Removal and Installation (AT4)
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Pipe Clip (1) - Disengage [8x]
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Pipe Clip (1) - Disengage
Rear Brake Pipe Nut (2) - Remove
Plug the rear brake crossover pipe inlet to prevent brake fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Maneuver the right rear brake pipe (1) out of the vehicle.