Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Remove the left front tire and wheel assembly. Tire and Wheel Removal and Installation
- Oil Filler Cap - Remove
Intake Manifold Cover (1) - Remove
- NOTE:
To avoid small parts like bolts or retainers fallen into the engine, install the Oil Filler Cap.
Oil Filler Cap (1) - Install
Positive Crankcase Ventilation Fresh Air Tube (1) @ Air Cleaner Outlet Duct - Disconnect - Plastic Collar Quick Connect Fitting Service
Turbocharger Outlet Duct Front Clamp (1) - Loosen
- Air Cleaner Outlet Duct Clamp (5) - Loosen
- Air Cleaner Outlet Duct Bolt (2) - Remove [2x]
- Air Cleaner Outlet Duct Nut (3) - Remove
- Air Cleaner Outlet Duct (4) - Remove
- NOTE:
Some components not shown for graphic clarity.
Radiator Surge Tank Bolt (1) - Remove
- Without opening the cooling system position the radiator surge tank (2) aside.
Rear Brake Pipe Fitting (1) - Remove
- Cap the brake master cylinder outlet to prevent brake fluid loss and contamination.
Brake Pipe (1) @ Front Brake Pipe Clip (2) - Disengage
- Remove and DISCARD the tape securing the brake pipes.
- Drivetrain and Front Suspension Cradle - Remove - Drivetrain and Front Suspension Cradle Removal and Installation (AWD) , or Drivetrain and Front Suspension Cradle Removal and Installation (FWD) , or Drivetrain and Front Suspension Cradle Removal and Installation (AT4)
- Rear Suspension Cradle - Remove - Rear Suspension Cradle Removal and Installation (AWD) , or Rear Suspension Cradle Removal and Installation (FWD)
Rear Brake Pipe Clip (1) - Disengage [9x]
Rear Brake Pipe Clip (1) - Disengage [5x]
Rear Brake Pipe Fitting (1) - Remove
- Plug the rear brake hose inlet to prevent brake fluid loss and contamination.
Maneuver the left rear brake pipe (1) out of the vehicle.