Removal Procedure
WARNING:
The battery must be disconnected to prevent the brake master cylinder from pressurizing the hydraulic system during its automated self diagnostic tests that can possibly occur when a door is opened or the key transmitter is activated. Failure to follow this precaution may cause personal injury.
WARNING:
WARNING:
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation
Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
Rear Brake Hose Bracket Nut (1) - Remove
Rear Brake Hose Fitting (2) - Remove
- Rear Brake Hose Fitting Gasket (3) - Remove and DISCARD [2x]
- Rear Brake Hose (1) @ Rear Brake Caliper - Remove
- Plug the rear brake hose fitting outlet to prevent brake fluid loss and contamination.