Removal Procedure

Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
Oil Filler Cap - Remove
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
To avoid small parts like bolts or retainers fallen into the engine, install the Oil Filler Cap.

Oil Filler Cap (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Positive Crankcase Ventilation Fresh Air Tube (1) @ Air Cleaner Outlet Duct - Disconnect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Outlet Duct Front Clamp (1) - Loosen
Air Cleaner Outlet Duct Clamp (5) - Loosen
Air Cleaner Outlet Duct Bolt (2) - Remove [2x]
Air Cleaner Outlet Duct Nut (3) - Remove
Air Cleaner Outlet Duct (4) - Remove
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Outlet Duct Rear Clamp (1) - Loosen
Turbocharger Outlet Duct Connector (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Radiator Surge Tank Bolt (1) - Remove
Without opening the cooling system position the radiator surge tank (2) aside.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector. (1)

NOTE:

Label the brake pipes to ensure they are re-installed in the correct ports of the brake master cylinder.

Brake Pipe Fitting (2) - Remove [4x]
Plug the brake master cylinder ports and the brake pipes to stop fluid loss and contamination.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector. (1)
Brake Master Cylinder Bracket Nut (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Brake Master Cylinder Bracket Nut (1) - Remove [2x]
With the aid of an assistant, hold the brake master cylinder away from the dash panel.
Courtesy of GENERAL MOTORS COMPANY

Brake Pedal Retainer (1) - Release

NOTE:

Pull the brake pedal rearward to release.

Brake Pedal (2) - Release
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Insert a long, thin tool through the power brake booster pass-through from the engine compartment to remove the brake pedal retainer.

Brake Pedal Retainer (1) - Remove and DISCARD
Courtesy of GENERAL MOTORS COMPANY

Remove the brake master cylinder (1) from the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Brake Master Cylinder Adapter Bolt (1) - Remove [2x]
Brake Master Cylinder Adapter (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Brake Master Cylinder Reservoir Bolt (1) - Remove [2x]
Brake Master Cylinder Reservoir Bolt (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Brake Master Cylinder Reservoir Seal (1) - Remove and DISCARD [3x]