Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Liftgate Upper Center Trim Finish Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Liftgate Inside Pull Handle Cover (1) - Remove
Liftgate Lower Trim Finish Panel Bolt (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Use a flat bladed plastic tool to remove.
Disconnect the electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Liftgate Lower Trim Finish Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Liftgate Upper Side Trim Finish Panel- Left Side and Right Side (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Disconnect all electrical connectors.

NOTE:

Typical wiring harness shown, individual harness may be different due to option content.