Removal Procedure
When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
When a liftgate hydraulic system component is removed, installed or disconnected, provide alternate support to avoid the possibility of damage to the vehicle, liftgate hydraulic system, or personal injury.
DO NOT exceed the limit of the liftgate power assist actuator ball socket joint's free motion during installation to prevent possibility of damage to the actuator.
- 3rd Row Seat - Remove - 3rd Row Seat Removal and Installation (- AS8) , or 3rd Row Seat Removal and Installation (AS8)
3rd Row Seat Belt Anchor Bolt (1) - Remove
- 3rd Row Seat Belt Buckle (2) - Reposition
Quarter Window Trim Finish Panel Bolt Cap (1) - Remove
- Body Rear Corner Upper Garnish Molding Bolt (2) - Remove
Body Rear Corner Upper Garnish Molding (1) - Remove
- Disconnect the electrical connector.
Disconnect the electrical connector. (1)
Disconnect the liftgate power assist actuator harness grommet (1).
- Release the 2 metal clips at the ends of the liftgate power assist actuator (2).
- Liftgate Power Assist Actuator (2) - Remove
- NOTE:
Left side shown, right side similar.
Liftgate Strut Bracket Bolt (1) - Remove [2x]
- Liftgate Strut Bracket (2) - Remove