Removal Procedure
WARNING:
When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
WARNING:
When a liftgate hydraulic system component is removed, installed or disconnected, provide alternate support to avoid the possibility of damage to the vehicle, liftgate hydraulic system, or personal injury.
CAUTION:
DO NOT exceed the limit of the liftgate power assist actuator ball socket joint's free motion during installation to prevent possibility of damage to the actuator.
- Support the liftgate with an alternative liftgate hold open device.
Remove the 2 metal clips at the ends of the liftgate strut (1).
- Liftgate Strut (1) - Remove
Liftgate Adjust Bumper (1) - Remove
Liftgate Side Bumper Bracket Bolt (1) - Remove
- Liftgate Side Bumper Bracket Stud (2) - Remove
- Liftgate Side Bumper Bracket (3) - Remove