Removal Procedure
Front Bumper Fascia (1) - Remove - Front Bumper Fascia Removal and Installation (Base) , or Front Bumper Fascia Removal and Installation (AT4)
Front Wheelhouse Liner (1) - Remove
Front Bumper Fascia Guide Bolt (1) - Remove [2x]
- Front Bumper Fascia Guide (2) - Remove
Headlamp Bolt (1) - Remove [2x]
Headlamp Bolt (1) - Remove
Headlamp Bolt (1) - Remove [2x]
- Disconnect the electrical connector.
Front Headlamp (2) - Remove
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Open both front and rear side doors
Front Wheelhouse Liner Bolt (1) - Remove
- Using an appropriate trim tool, release the front wheel opening molding retainers.
- Front Wheel Opening Molding (2) - Reposition
Rear Tire Front Air Deflector Bolt (1) - Remove
Rear Tire Front Air Deflector Bolt (1) - Remove [2x]
- Rear Tire Front Air Deflector- Upper (2) - Remove
Using an appropriate trim tool, release the rocker panel molding retainers (1) and pull the rocker panel molding (2) away from the body side outer panel.
- Rocker Panel Molding (2) - Remove
Front Wheelhouse Liner (1) - Remove - Front Wheelhouse Liner Replacement
Front Fender Washer (1) - Remove
- Front Fender Insulator (2) - Remove
- NOTE:
Left side shown, right side similar.
Air Inlet Grille Panel Extension (1) - Remove
- NOTE:
Left side shown, right side similar.
Release the retaining tabs.
- Front Fender Upper Rear Molding (1) - Remove
Using the appropriate tool, release the foam insulation on the front compartment side rail baffle (1) from the fender.
Front Fender Bolt (1) - Remove [2x]
Front Fender Bolt (1) - Remove
Front Fender Bolt (1) - Remove
- Front Fender Bolt (2) - Remove
Front Fender Bolt (1) - Remove [3x]
- Front Fender Nut (2) - Remove
Front Fender (1) - Remove