Front Wheel Opening Molding Replacement
 Courtesy of GENERAL MOTORS COMPANY
|
NOTE:
Callouts in the following chart represent components shown in graphic above.
| Callout |
Component Name |
| 1 |
Front Wheel Opening Molding Retainer [18x] |
| 2 |
Front Fender Wheel Opening Molding Procedure
- Apply two layers of masking tape around the top edge of the front wheel opening molding to prevent any paint surface damage.
- Using a suitable flat bladed plastic tool, release the retainers from the front fender.
- Pull upward to release the molding from the front bumper lower fascia.
- Using a 50/50 mixture of isopropyl alcohol and clean drinkable water and a clean towel, remove the left over adhesive residue from the masking tape.
|