Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Install a NEW brake pedal retainer (1) to the brake pedal.
Ensure the locking tabs on the brake pedal retainer are fully engaged in the brake pedal.
Courtesy of GENERAL MOTORS COMPANY

Maneuver the brake master cylinder (1) into the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Engage the brake pedal (1) to the brake master cylinder push rod by pushing inwards.
Ensure the brake pedal retainer is secured by lightly pulling rearward on the brake pedal (1).
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) @Brake System Control Module - Connect
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Fastener Caution

Brake Master Cylinder Nut (1) - Install and tighten [3x] 22 N.m (16 lb ft)
Courtesy of GENERAL MOTORS COMPANY

Remove the caps from the 4 brake pipe inlets.
Reposition the brake pipes (1) and install and tighten the 4 front brake pipe nuts (2) to 18 N.m (13 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Brake Master Cylinder Reservoir (1) - Install - Brake Master Cylinder Reservoir Replacement
Radiator Surge Tank - Install - Radiator Surge Tank Replacement
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
Reprogram the brake system control module. Control Module References
Bleed the brake system. Hydraulic Brake System Bleeding (Manual) , or Hydraulic Brake System Bleeding (Pressure)
Check the brake system for leaks.