Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

]

Connect the electrical connector.

NOTE:

Ensure that the tab on the head-up display is properly seated in the mating hole for proper alignment.

Head-Up Display (2) - Install

CAUTION:

Refer to Fastener Caution .

Head-Up Display Bolt (1) - Install and tighten [2x] 2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Head-Up Display Bolt (1) - Install and tighten [2x] 2.5 N.m (22 lb in)
Courtesy of GENERAL MOTORS COMPANY

Instrument Cluster (2) - Install - Instrument Cluster Replacement (Terrain)
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Cluster Trim Plate (1) - Install - Instrument Panel Cluster Trim Plate Replacement (Terrain)
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Pad - Right Side (1) - Install - Instrument Panel Trim Pad Replacement - Right Side (Terrain)
Courtesy of GENERAL MOTORS COMPANY

Electronic Transmission Shift Control Pushbutton (2) - Install - Electronic Transmission Shift Control Pushbutton Replacement (Terrain)
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Transmission Shift Opening Bezel (1) - Install - Front Floor Console Transmission Shift Opening Bezel Replacement (Terrain)
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Pad - Left Side (1) - Install - Instrument Panel Trim Pad Replacement - Left Side (Terrain)
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Extension (1) - Install - Instrument Panel Extension Replacement (Terrain without UV7) , or Instrument Panel Extension Replacement (Terrain with UV7)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Install the left and right instrument panel outer trim cover (1). Instrument Panel Outer Trim Cover Replacement (Terrain)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Install the left and right windshield garnish molding (1). Windshield Garnish Molding Replacement (Terrain)