Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Rear Side Door Armrest Pull Cup Bolt Cap (1) - Remove
Rear Side Door Armrest Bracket Bolt (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Rear Side Door Trim Panel Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The rear side door trim has an integral rear side door trim assembly belt bracket that hooks over the rear side door window inner sealing strip assembly.

Using an appropriate tool, start from the rear bottom corner and pull the rear side door trim (3) from the sheet metal towards you to disengage perimeter retainers (1).
When the rear side door trim (3) is sufficiently loosened, place an appropriate tool at the front portion of the door trim to disengage the remaining retainers (1) and clip (2).
Unhook the rear side door trim (3) from the belt line, pulling the door trim upwards using both hands.
Disconnect the door lock retainer cable from the rear side door trim (3) and the inside handle.
Disconnect the electrical connectors.
Rear Side Door Trim (3) - Remove
Place the rear side door trim (3) on a clean flat surface.
Courtesy of GENERAL MOTORS COMPANY

Rear Side Door Check Link Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using the appropriate tool, remove both upper weatherstrip retainers (1) from the rear side door weatherstrip.
Courtesy of GENERAL MOTORS COMPANY

Remove both inboard weatherstrip retainers (1) and the rear side door weatherstrip (2) from the rear side door panel.
Courtesy of GENERAL MOTORS COMPANY

Remove both outboard weatherstrip retainers (1) and the rear side door weatherstrip (2) from the rear side door panel.
Courtesy of GENERAL MOTORS COMPANY

Remove the weatherstrip retainers (1) from around the rear side door panel.
Rear Side Door Weatherstrip - Door Side (2) - Remove