Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Remove the 4 front compartment front sight shield clips (1)
Front Compartment Front Sight Shield Retainer (2) - Release [2x]
Front Compartment Front Sight Shield (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Turn the 6 left side and right side front compartment sight shield retainers (1) one quarter turn counterclockwise to release.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Compartment Side Sight Shield- Left Side and Right Side (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Using the appropriate tool, release the integral clips on both sides of the vehicle.
Remove the left and right side front compartment side sight shield -front (1).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Open the 4 cargo tie down loop access covers with an appropriate tool.
Cargo Tie Down Loop Bolt (1) - Remove [4x]
Cargo Tie Down Loop (2) - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Trim Finish Compartment Bolt- Left Side and Right Side (1) - Remove [2x]
Front Trim Finish Compartment Closeout Cap- Left Side and Right Side (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector and harness retainers as needed.
Front Trim Finish Compartment Bolt (1) - Remove [10x]
Front Trim Finish Compartment (2) - Remove
Place the front trim finish compartment (2) on a clean flat surface.