Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Tire Repair Sealer and Tire Air Compressor Retainer (1) - Remove
Tire Air Compressor (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rear Floor Mat (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Move the front seat to access the retainers.

NOTE:

Use a flat bladed plastic trim tool.

Front Floor Console Bolt Access Hole Cover (1) - Remove
Front Floor Console Rear Cover Bolt (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Move the front seat to access the retainers.

NOTE:

Use a flat bladed plastic trim tool.

Front Floor Console Bolt Access Hole Cover (1) - Remove
Front Floor Console Rear Cover Bolt (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Open the armrest cover.
Release the retainers with a suitable plastic trim tool.
Front Floor Console Rear Trim Plate (1) - Remove
Front Floor Console Rear Cover Bolt (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Release the retainers with a suitable plastic trim tool.
Reposition the component to access the electrical connectors.
Disconnect the electrical connectors.
Front Floor Console Rear Trim Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Dual Charge Only Receptacle (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Heater and Air Conditioning Auxiliary Control Bolt (1) - Remove [4x]
Heater and Air Conditioning Auxiliary Control (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Release the retaining tabs.
Front Floor Console Rear Air Outlet (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Using a suitable plastic trim tool, release the retaining tabs.
Accessory Power Receptacle (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Release the retaining tab.
Low Frequency Console Number 2 Antenna (1) - Remove